Super Powerful 250A - 12V, 24V, 36V, 48V DC PWM MOTOR SPEED CONTROL Controller HHO

Price: $249.00
Product prices and availability are accurate as of 2017-11-07 09:24:18 EST and are subject to change. Any price and availability information displayed on http://www.amazon.com/ at the time of purchase will apply to the purchase of this product.
Availability: Not Available - stock arriving soon
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED 'AS IS' AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Manufacturer Description

Model: PWM250
Smoothly regulates speed of DC Motors and other DC loads, from 0 to 100% of power.
This is a DUAL 125-Amp controller, so you can either connect TWO 125A DC Motors, or ONE 250A DC motor , using TWO sets of cables (to parallel the two 125A outputs). And one Potentiometer controls both outputs. The pot comes with wires attached.
Can be powered from 12, 24, 36, or 48 Volts DC. Uses two large heatsinks.
This "mother of all speed controllers" is Great for regulating Powerful Loads in ROBOTICS, GOLF and KID CARTS, ELECTRIC BIKES and SCOOTERS, TROLLING MOTORS, for EXPERIMENTERS, and testing and troubleshooting DC motors.
Simple to use; just connect power, load (motor), and the potentiometer to the screw-in terminals. The terminals accept up to 2 Gauge cables, but for short distances 4 to 8 gauge wires can be used. The potentiometer now comes with a cable attached, so no soldering is required.
Specs:
Supply Voltage: 8 to 48 Volts DC
Load Current: Two output sections, each 125 AMPS Continuously, or both sections (in parallel) for 250 Amps continuously.
Type of Load: Both, resistance and inductive loads.
Range of regulation: PWM 0 to 100% of power.
Size: 6.8 x 4 x 1.7"
Switching Frequency: 3.5 kHz.
Overheating protection: When the module is overloaded, power is automatically decreased, in order to protect mosfets from destruction.
This is NOT A KIT, this module is fully assembled as shown in the picture.

Will control loads of up to 2 x 9HP or 1 x 18HP.

Comes with instructions.

Product Features

Controls loads of up to 2 x 9HP or 1 x 18HP. Can be powered from 12, 24, 36, or 48 Volts DC. This is a DUAL 125-Amp controller, so you can either connect TWO 125A DC Motors, or ONE 250A DC motor. Great for regulating Powerful Loads in ROBOTICS, GOLF and KID CARTS, ELECTRIC BIKES, SCOOTERS, and TROLLING MOTORS. The terminals accept up to 2 Gauge cables.

Write a Review